IP Addressing and Subnetting

Introduction

This document gives you basic information needed in order to configure your router for routing IP, such as how addresses are broken down and how subnetting works. You learn how to assign each interface on the router an IP address with a unique subnet. There are many examples to help tie everything together.

Prerequisites

Requirements

Cisco recommends that you have knowledge of these topics:

• Basic understanding of binary and decimal numbers.
  

Components Used

This document is not restricted to specific software and hardware versions.

Additional Information

If definitions are helpful to you, use these vocabulary terms to get you started:

• Address—The unique number ID assigned to one host or interface in a network.
  
• Subnet—A portion of a network sharing a particular subnet address.
  
• Subnet mask—A 32-bit combination used to describe which portion of an address refers to the subnet and which part refers to the host.
  
• Interface—A network connection.
  

If you have already received your legitimate address(es) from the Internet Network Information Center (InterNIC), you are ready to begin. If you do not plan to connect to the Internet, Cisco strongly suggests that you use reserved addresses from RFC 1918 .

Conventions

Refer to Cisco Technical Tips Conventions for more information on document conventions.

Understanding IP Addresses

An IP address is an address used in order to uniquely identify a device on an IP network. The address is made up of 32 binary bits, which can be divisible into a network portion and host portion with the help of a subnet mask. The 32 binary bits are broken into four octets (1 octet = 8 bits). Each octet is converted to decimal and separated by a period (dot). For this reason, an IP address is said to be expressed in dotted decimal format (for example, 172.16.81.100). The value in each octet ranges from 0 to 255 decimal, or 00000000 - 11111111 binary.
Here is how binary octets convert to decimal: The right most bit, or least significant bit, of an octet holds a value of 2⁰. The bit just to the left of that holds a value of 2¹. This continues until the left-most bit, or most significant bit, which holds a value of 2⁷. So if all binary bits are a one, the decimal equivalent would be 255 as shown here:

    1  1  1  1 1 1 1 1
  128 64 32 16 8 4 2 1 (128+64+32+16+8+4+2+1=255)

Here is a sample octet conversion when not all of the bits are set to 1.

  0  1 0 0 0 0 0 1
  0 64 0 0 0 0 0 1 (0+64+0+0+0+0+0+1=65)

And this is sample shows an IP address represented in both binary and decimal.

        10.       1.      23.      19 (decimal)
  00001010.00000001.00010111.00010011 (binary)

These octets are broken down to provide an addressing scheme that can accommodate large and small networks. There are five different classes of networks, A to E. This document focuses on addressing classes A to C, since classes D and E are reserved and discussion of them is beyond the scope of this document.